Harness a TORNADO to your Mill

Are you looking for

A better particle size reduction, grinding, pulverizing or milling technology?

Reduced milling and maintenance cost?

Homogeneous particle size distribution?

Reduced tails of coarse or super fine particle size?

A specific particle size or particle size distribution?

Micron or sub-micron particle size?

or have a material that is difficult to grind using available pulverizing technologies?

The VORTEX MILL may be the answer

The Vortex Mill is a new, innovative, patented milling technology. The mill, which does not have moving parts, reduces the size of a wide range of materials (from very soft materials such as plastics and rubber to very hard materials such as Zirconia and Boron Nitride) to micron and sub-micron particles, in a single step, continuous process. The new technology, which is not based upon mechanical forces such as sheering, grinding or crushing, offers unprecedented advantages in terms of both powder quality and energy consumption.

CAPABILITIES

Versatility        - Pulverizes a wide range of materials

Particle size    - Micronizes large particles to micron and sub-micron size

Efficiency        - Provides an impressive milling ratio of up to 1:1000.

ADVANTAGES

       Quality

Purity                        -  The raw material is not contaminated

Ultra-fine Powder  -  Non-mechanical pulverizing system results in greatly

                                                reduced quantities of unwanted ultra-fine powder

       Economy 

 Low Energy Consumption - Low pressure work regime of 1.5 to 3.5 Bars at

            a low airflow rate, means low energy  consumption

 High Efficiency -

1. High pulverizing coefficient of up to 1000
2. A single stage pulverizing process delivers super fine powders
3. Minimum maintenance: The compact system with no moving parts greatly reduces maintenance costs

All you need to do is to send us your specifications.

If this technology is considered suitable to your needs, we will ask you to provide a sample of your material(s). An initial laboratory milling trial will be conducted free of charge and the pulverized sample returned to you for your evaluation.

Contact us at tornado@hydan.com or fill in the following form: